The blades, wings, corner pins or needle teeth on the high-speed rotating percussion parts (commonly known as beaters) are used to strike the feeding fiber raw materials or pierce into the fiber layer at the same time for segmentation and carding, thus destroying the bonding force between fibers and between fibers and impurities, so as to further release fiber blocks and remove impurities. Loosening is usually carried out on the basis of pulling loose. After loosening, the fiber block can be rel

The degree of loosening of the fiber material by the loosening machine is usually expressed by the number of blows per meter of fiber layer fed to the roller or the number of blows per gram of fiber layer. The opening quality of fiber can be improved by increasing the number of blows in a certain range. However, if the number of blows is too much, it is easy to cause fiber damage and impurity fragmentation, which will increase fiber defects and affect yarn quality.

Before the cotton wadding passes through the fine spring machine, it will be opened and combed by the opening machine or small-sized machine to open and comb the impurities. The two processes of opening impurities and fine and uniform carding are combined into one, which saves labor and time. The traditional carding machine can only comb wool, chemical fiber and other fiber textiles, and the processing effect of cotton is not very good Good, the improved opening and combing machine fine spring m

The blades, wings, corner pins or needle teeth on the high-speed rotating percussion parts (commonly known as beaters) are used to strike the feeding fiber raw materials or pierce into the fiber layer at the same time for segmentation and carding, thus destroying the bonding force between fibers and between fibers and impurities, so as to further release fiber blocks and remove impurities. Loosening is usually carried out on the basis of pulling loose. After loosening, the fiber block can be rel

The machine is suitable for processing cloth block, cloth end, yarn end, knitting cloth block, etc. After processing, it is convenient for the material to enter the cleaner and lengthen the fiber. The fiber lengthening effect of gm600 + gm550 double opener is better than that of one opener.

The opening of fiber materials has been done by hand. For example, for wool, the tufts are torn and shaken by hand. Then beat it with a stick or use a bow string to loosen it. For seed cotton, the cotton seed is separated from the fiber by hand, and then the fiber is loosened by bowstring. Until the advent of machine spinning in the 18th century, it was necessary to have more raw material reserves and to reduce the transport volume of raw materials. Therefore, loose fiber raw materials were bund

Before the cotton wadding passes through the fine spring machine, it will be opened and combed by the opening machine or small-sized machine to open and comb the impurities. The two processes of opening impurities and fine and uniform carding are combined into one, which saves labor and time. The traditional carding machine can only comb wool, chemical fiber and other fiber textiles, and the processing effect of cotton is not very good Good, the improved opening and combing machine fine spring m

The cleaning machine (also known as cotton cleaner, cotton opener, cotton opener, etc.) is a kind of mechanical centrifugal force generated by the high-speed operation of carding device and taker in roller to remove impurities in brocade flower, and loosen lint and roll it into pieces, which is easy to use. It has the advantages of reasonable structure, compact model, low noise, high output, good processing effect, small fiber damage, simple operation, safe and convenient.It can be widely used i

The process of releasing and removing impurities from compressed, entangled fiber materials. All kinds of fiber materials used in spinning, such as raw cotton, wool, chemical staple fiber, cotton, hemp, polyester, rags, etc., are mostly transported into textile mills in bales. The packing density of raw materials is generally 200-650 kg / m3, while the packing density of raw cotton in China is about 330-400 kg / m3. In order to produce high quality spinning yarn, it is necessary to loosen the ra